Information about MICROMASTER is also available from: Regional Contacts .. change this parameter setting in all three inverter states. 4. P-Group. Siemens AG MICROMASTER. // Inverters. kW to kW. Catalog DA / The products and sys- tems described in this. Siemens Micromaster (MM) Series AC Frequency Inverter for kW ( HP) V 3 Ph motor in VxF control to 3A. Simple set-up and ready to run from.
Author: | Kimuro Shat |
Country: | Peru |
Language: | English (Spanish) |
Genre: | Automotive |
Published (Last): | 21 July 2014 |
Pages: | 58 |
PDF File Size: | 4.66 Mb |
ePub File Size: | 19.63 Mb |
ISBN: | 910-8-98339-703-8 |
Downloads: | 95310 |
Price: | Free* [*Free Regsitration Required] |
Uploader: | Nit |
Check load conditions and duty cycle 3. Inverter may run but certain actions will not function correctly 2. Motor cable and motor must have no short- circuits or earth faults 4. Please how to replace motor of dishwasher Siemens lady Motor power P must match inverter power P Check that the cable length limits have not been exceeded 3. Check loading on diemens 3. Load must match In certain cases apply braking resistor — A Vdc-max controller active Vdc max controller is active; so ramp- down times will be increased automatically to keep Mjcromaster voltage r within limits P 1.
Siemens Micromaster 420 4kW 400V 3ph AC Inverter Drive, C3 EMC
Cycle the power to the drive. Increase ramp down times Note: Air inlet and outlet points are not obstructed Ambient temperature could be higher than specified for the invreter.
Analogue input parameters should not be set to the same value as each other. Check whether the motor power corresponds to the inverter power 2.
P Motor i2t overload warning level should be set to suitable level 3. Via Digital Input 3 default setting. DAC parameters should not be set to identical values, since this would produce illogical results. Motor parameters siemwns match the motor in use 5. Reading of the powerstack information has failed or the data is invalid. Check that the motor data has been entered correctly. Supply voltage P must sieemens within limits indicated on rating plate 2.
Siemens Micromaster kW V AC Inverter Drive, No Filter – AC Inverter Drives (V)
Hopefully, this helps with your troubleshooting. Parameter settings for input do not correspond to ADC type. Have you any thoughts? Cable length limits must not be exceeded 3. DC-link voltage controller must be enabled P and parameterized properly 3. Ramp-down time P must match inertia of load. I remove the power cable of the motor but no use.
Check that boost settings are not too high. micrromaster
Input voltage P lies within range? It has also taken to stopping after a few minutes intermittently.
Check connections to the communications board 2. Vdc-max controller is active, ramp-down times will be automatically increased.
Siemens Micromaster 420 1.1kW 400V AC Inverter Drive, No Filter
Hi all I have fault F on micromaster Check if fan is turning when drive is running. Increase the ramp-up-time 7. Value of stator resistance P must be correct 6.
Parameter settings for output do not correspond to DAC type. I have fault F on micromaster