EEPROM 95160 PDF

STMicroelectronics MW Series EEPROM are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for STMicroelectronics . Errors and solutions here for eeprom read/write with Carprog programmer: Error 1: “ID not found” when read eeprom EEPROM, Serial SPI, 16 Kbit, 2K x 8bit, 10 MHz, SOIC, 8 Pins The M WMN6P is a 16Kbit (2K x 8bit) serial SPI bus EEPROM (Electrically Erasable.

Author: Faejind Tygogar
Country: Hungary
Language: English (Spanish)
Genre: Life
Published (Last): 8 September 2009
Pages: 375
PDF File Size: 18.23 Mb
ePub File Size: 15.3 Mb
ISBN: 946-5-59062-799-2
Downloads: 17811
Price: Free* [*Free Regsitration Required]
Uploader: Kajik

Carprog 9.31 reads/writes eeprom 95160 with A4/A6 adapter

Chip is blank does this mean this chip is empty??? Reply 14 benaknoun Spain Posts.

What is your another adapter part number? Also, when i click on ID, it says “function not supported on this device” Image Insert: When you uploading the image, only use letter and number as file name.

Use ToolA instead, because your chip pins already damaged. Reply 4 benaknoun Spain Posts. Reply 3 ZLM Posts.

Carprog reads/writes eeprom with A4/A6 adapter | OBDIIcom Official Blog

Once the chip is blank, then you can load your data file and click on Write button to wrtie the data into chip. Reply 6 benaknoun Spain Posts. Eepeom is depending eerom your circuit design. The wire can be any wires, as long as you can solder it. If the chip is not designed for programming in circuit, then you need to try to find some connection. So, if you can not read anything out, make sure your pins have good contacting. It should be able to open it by same software. Most of used on-board chips should have something.

  CUSHCRAFT X9 PDF

All other pins are pin to pin connect to programmer socket. That is safe and fastest way. Reply 9 ZLM Posts.

MCUmall EPROM BIOS Chip Burner Forum – 8pin

Then the ADP should be used. You need to find a way to test the data. It is SOIC8 mil chip. Hi, thanks for your reply, here are the numbers on the chip: Hi, ok forget this chip, its damaged Reply esprom benaknoun Spain Posts. If it is “”, then it has no ID on this chip.

Reply 15 ZLM Posts. You can save data as.

I think it should be SOIC8 mil chip. Hi, it seems i’m doing something right then! Hi, i have connected the tool to the chip and adapter to the programmer.

Which part number you selected in eerpom Reply 18 benaknoun Spain Posts. Reply 11 benaknoun Spain Posts. The only way to test data is: To be honest though, the other adapter i bought, not sure what its for??

  LOS ESCARABAJOS VUELAN AL ATARDECER PDF

Device blank check failed at address: Reply 19 ZLM Posts. Reply 5 ZLM Posts. Try to power up the board and eepro, not connect pin 8 Vcc pin. Reply 2 benaknoun Spain Posts. Reply 16 benaknoun Spain Posts.

Reply 12 ZLM Posts. Reply 10 benaknoun Spain Posts. Reply 8 benaknoun Spain Posts. What is your chip on board?

What is exact part number? I believe they will do the job. Hi, i have received the tools i bought from mcumall canada, there are numbers on the adapters, how do i know which pin is the right matching one with the chip?