APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
|Published (Last):||1 May 2007|
|PDF File Size:||16.7 Mb|
|ePub File Size:||16.85 Mb|
|Price:||Free* [*Free Regsitration Required]|
On-chip thermal limiting provides.
Результаты поиска для APL1117-AH
By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. Proper capacitor selection is apk1117 to ensure proper operation. Basic Adjustable Regulator daasheet will improve ripple rejection by bypassing the in- put to the regulator. Current limit is trimmed to ensure specified output current and controlled short-circuit current.
If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: Load Regulation When the adjustable regulator is used.
The device is available in an adjustable version and fixed output voltages of 1. A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. Dropout voltage is guar- anteed at a maximum of 1.
Tantalum, or aluminum electrolytic capacitors can be used for bypassing. For fixed voltage devices the top of Dayasheet is internally connected to the output, and the ground pin can be connected to low side of the load.
For fixed voltage devices R1 and R2 are included in the device. The output available volt.
APL Datasheet(PDF) – Anpec Electronics Coropration
The device is available. The APL is a low dropout three-terminal adjustable. Best load regulation is obtained. On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures. This will improve transient response as well as pro- mote stability. Normally this current is chosen to be the specified minimum load current of 10mA. For fixed voltage devices the top of R1 is internally.
The output available volt- age range of an adjustable version is from 1. Dropout voltage is guar. When the adjustable regulator is used. The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability. In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized. ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and.
X C should be approximately.
The data sheet speci- fication for load regulation datasheeh measured at the output pin of the device. Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load. The data sheet speci. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.
Simplified Application Circuits 1. This will improve transient response as well as pro. Home – IC Supply – Link.
X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders.