61F-GPN2 AC from OMRON >> Specification: Liquid Level Controller, 61F- GP-N2 Series, Conductive, Vac, W, 80 ms. Find great deals for Omron 61F-GP-N2 Processor/Controller. Shop with confidence on eBay!. The 61F-GP-N2-AC is a Conductive Level Controller for automatic water supply and drainage control. Compact plug-in controller for single or two-point.
|Published (Last):||5 April 2010|
|PDF File Size:||6.31 Mb|
|ePub File Size:||1.3 Mb|
|Price:||Free* [*Free Regsitration Required]|
However, some specifications of the Product may be changed without any notice. Doing so can reduce some effects of noise. These are cut to length and inserted vertically into the liquid. When resistance to high pressure is required.
For acids, alkalis and sea water, electrode holders may be as much as 1 meter apart to operate properly. Ideal for soft drink vendors, etc. Using the low-level probe allows 61f-gp-2n wide differential between switching a pump on and off, and can avoid excessive pump operation during tank emptying or filling. Special 3-pole holder of small size and light weight.
61F-GP-N2 – OMRON Industrial Automation
Product specifications and accessories may be changed at any time based on improvements and other reasons. Information presented by Omron Companies has been checked and is believed to be accurate; however, no responsibility is assumed for clerical, typographical or proofreading errors or omissions. Use separator when connecting. The diagram shows the connections for water supply. Doing so causes malfunctions by getting vulnerable to induction noise.
Lock nut Electrode 2. In this case the relay does not de-energize until the water 61f-p-n2 falls below the low-level probe. When draining, change the connection Tb to Ta. This information by itself is not sufficient for 61-gp-n2 complete determination of the suitability of the Product in combination with the end product, machine, system, or other application or use.
Please read and understand this catalog before purchasing the products. 61f-gp-2
Conductive level switch / for water / compact – 61F-GP-N2 – OMRON
Used for sewage, sea water, etc. Omron Companies shall not be liable for the suitability or unsuitability or the results from the use of Products in combination with any electrical or electronic components, circuits, system assemblies or any other materials or substances or environments. To convert millimeters into inches, multiply by 0. Tighten the omroj with the two clamp screws.
Make sure that the terminal cover is 61t-gp-n2 before using the product. Data presented in Omron Company websites, catalogs and other materials is provided as a guide for the user in determining suitability and does not constitute a warranty. Usually, electrodes are used in a set of three: Further, in no event shall liability of Omron Companies exceed the individual price of the Product omro which liability is asserted. Similarly, avoid using next to a high-capacity contactor which may impacts at operation.
Limitation on Liability; Etc.
When the required length of the electrode is more than 1 m, use a separator at each joint of two electrodes so as to prevent the electrodes from contacting one another. Electrochem review part 1 61f-fp-n2 the following two reactions: Avoid use of the separators in dust-containing liquids. Alarm control warning of abnormal or dangerously high or low levels. Doing so may possibly result in electric shock. Iron is more reactive than ommron.
When using a noise filter, check the voltage and current and install it as close to the product as possible. The earth terminal must be grounded.
Omron 61F-GP-N2 Processor/Controller
In sewage use, electrode holders must be installed 10 to 20 cm apart from one another. Return of any Products by Buyer must be approved in writing by Omron before shipment.
Precautions for Safe Use 1. The output relay in the controller is energized when the water level reaches the high-level probe and de-energized when the water level falls below it. Any advice, recommendations or information given orally or in writing, are not to be construed as an amendment or addition to the above warranty. However, a type having 1, mm length electrodes is available on request. The water provides a current between the earth probe and the high-level probe.
Connect the short electrode to E1, the medium electrode to E2, and the 61f-bp-n2 electrode to E3. Omron disclaims all other warranties, express or implied.